Blooming Backer with Pattern 30" x 6" x 1/2" (pre-drilled for hanging kit)

Blooming Backer with Pattern 30" x 6" x 1/2" (pre-drilled for hanging kit)A brand new mosaic backer with the pattern "scored" on the front. Uniquely developed by Skeew. Each backer is precision cut with a laser then scored by the laser so you can easily mosaic this Skeewbacker. PLEASE NOTE: NO PAPER PATTERNS INCLUDED THE PATTERN IS PRINTED DIRECTLY ON THE SKEEWBACKER. Size: 30" x 6" x 1 2" PLEASE ALLOW 3 5 BUSINESS DAYS FOR PRODUCTION TIME IMPORTANT INSTRUCTIONS FOR ADDING HANGING SYSTEM: 1). Measure 10" from left and 20"

A brand new mosaic backer with the pattern "scored" on the front. Uniquely developed by Skeew. Each backer is precision cut with a laser then scored by the laser so you can easily mosaic this Skeewbacker. PLEASE NOTE: NO PAPER PATTERNS INCLUDED - THE PATTERN IS PRINTED DIRECTLY ON THE SKEEWBACKER.

Size: 30" x 6" x 1/2"

PLEASE ALLOW 3-5 BUSINESS DAYS FOR PRODUCTION TIME

IMPORTANT INSTRUCTIONS FOR ADDING HANGING SYSTEM:

1). Measure 10" from left and 20" from right and just below center, make a mark with pencil.

2). Use a sharp pick and piece through your marks - all the way through.

3). Place t-nuts over mark and lightly tap in with hammer on the front side, centered over your holes. - the score marks can break or compress a little, but that's OK if they do as you will mosaic over them. Turn over and use same straight pick to enlarge hole on back.

4). Do not put in hangers on back side yet; wait until all finished with mosaic so you can work flat. When finished, put the screw, washer and d-ring into the backside in the holes you previously drilled and tighten gently. You can either string a wire between the 2 d-rings or you can hang each d-ring over an individual nail in the wall.

Treatment options for edges:

 - you can paint the edges and back with paints that do not contain solvents of any kind as they will warp the board. Use latex or acrylic paints.

- you can thinset the edges

- you can grout the edges